Your cartThere are no more items in your cart
Toggle Switch MTS-102
No goggles for use this toggle.
- Support: 6A 125VAC max ou 3A 350v
2 SPDT ON-ON 3A / 250V AC à souder -25...85°C ronde Ø6mm 11mm 2
- Poids brut: 4.75 g
Customers who bought this product also bought:
The AD8232 based module is a cost-effective board used to measure the electrical activity of the heart. This electrical activity can be charted as an ECG or Electrocardiogram and output as an analog reading. ECGs can be extremely noisy, the AD8232 Single Lead Heart Rate Monitor acts as an op amp to help obtain a clear signal from the PR and QT Intervals...
This is a 5V 1-Channel Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
Z78 84.5x154x42.5 with Plastic case (CP-Z-78/B) BOX
Power and Energy
This holder can be holded 4 pieces 18650 battery.
High power mosfet to switch all your devices/leds/motors easily. This is the N-type, meaning you have to put it between the load and the ground.
Power and Energy
This is a simple to use voltage régulator that outputs 5V at 1.3A
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
The TB6612FNG motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop.
no odor finely drilled tough including power pad. Clean hole
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.