Your cartThere are no more items in your cart
Solderable Breadboard PCB ( protoboard )
Breadboard layout PCB board, including two power channels on the side, and all same prototyping holes in the middle. This is a small size breadboard-style PCB board. Double side board.
- Two installation screw holes
- Four of these PCBs panelized into one, each purchase if for one penzlied board.
- You can send the edge a little bit if you mind it (see this little issue on the pictures).
- Double side.
- Pin pitch 2.54 mm
- Dimension: 95*65 mm
Customers who bought this product also bought:
Digital RGB ring is an intelligent light source consist s of WS2812B RGB LED with Integrated Driver Chip. The control circuit and RGB chip are integrated in a package of 5050 components. This LED ring is a full-color that external control for each lamp beads. It with high brightness, can achieve effects of full color running water, chasing and scan. The...
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
This cheap 20x4 characters lcd is perfect for use with an arduino or any other microcontroller to display data quickly. It is compatible with the Hitachi HD44780 lcd driver.
Relay Shield V2, use relay to control other equipment.
Design a clock, timer or counter into your next project using this pretty 4-digit seven-segment display. These bright crisp displays are good for adding numeric output. Besides the four 7-segments, there are decimal points on each digit and an extra wire for colon-dots in the center (good for time-based projects) and a top right hand dot which could be...
This is an E-Ink display module, 1.54inch, 200x200 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like ultra low power consumption, wide viewing angle, great effect under sunlight, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
This is a SD / MicroSD card breakout board, and it will allow you to breakout the SD/MMC socket to a standard 0.1" x 6-pin header. It can work with 5V or 3.3V power supply, and both 5V/3.3V IO operation level. It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
This is a digital temperature sensor, that is already calibrated. The measurement is done where the sensor is, no need for long insulated wire or complicated ADC design. This sensor is therefore also perfect for use with a Raspberry Pi, as it is not analogic, all the data is transmitted in digital One Wire protocol.
Power and Energy
solar panel is made of single-crystal material that performs high solar energy transformation efficiency at 17%. It has a fine resin surface and sturdy back suitable for outdoor environments. A 2mm JST connecter is attached to the penal, which makes it perfect to team up with most of our can-use-solar-power-supply boards.