Your cartThere are no more items in your cart
MT3608 2A DC-DC Boost Step-up ADJ Power Module
Up to 2A current output, wide range input voltage from 2-24V, output 5/9/12/ – 28V, adjustable.
- Maximum output current: 2A
- Input voltage: 2 v ~ 24 v
- Maximum output voltage: 5V ~ 28 v
- Efficiency:> 93%
- Mechanical size: 36 mm * 17 mm * 14 mm
- Instructions: Connection module + and – input voltage 2 ~ 24 v, then adjust the potentiometer you can adjust the output voltage, output voltage higher than the input voltage
- Input voltage should not exceed the maximum input voltage
- Peak current output current does not exceed 2A
Customers who bought this product also bought:
The ADXL335 is a small, thin, low power, complete 3-axis accelerometer with signal conditioned voltage outputs. The product measures acceleration with a minimum full-scale range of ±3 g. The module was designed as breakout board because ADXL335's signal is analog( more ports requested ),but the board outline is grove module that you can fix it...
MAX30100 Heart Rate Pulse Sensor Module
Input with MICRO USB female, can directly use mobile charger for input to the lithium battery.And still retain the input voltage wiring solder joints, can be very convenient to DIY.
Easy to use Darlington Transistor Array for all your projects.
PN532 NFC module, as its name implies, is based on PN532 chip and used for 13.56MHz near field communication. The module is equipped with onboard antenna, thus no external antenna coil is needed. It is compatible with SPI, IIC and UART interface for communication. With NFC library support for Arduino and Raspberry Pi offered by us, it is quite convenient...
The BMI160 is a small, low power, low noise 16-bit inertial measurement unit designed for use in mobile applications like augmented reality or indoor navigation which require highly accurate, real-time sensor data. In full operation mode, with both the accelerometer and gyroscope enabled, the current consumption is typically 950 μA, enabling always-on...
There are many ultrasonic ranger module on the market, but sometimes, these kind of sensor needs to work in conditions more than the Lab. This water proof ultrasonic sensor meets this requirement. It has a good performance and almost the same usage of HC-S04 module.
Battery holder for 1x18650
ESP-WROOM-32, ESP32 WIFI+BT+BLE Module
Quadruple Half-H Drivers L293 DIP16