Your cartThere are no more items in your cart
male female splittable jumper wires (200mm, 40 pins) (cable)
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Cables of 200mm, male female pins, 40 wires assembled as one splittable cable.
Customers who bought this product also bought:
The Arduino CNC Shield makes it easy to get your CNC projects up and running in a few hours. It uses opensource firmware on Arduino to control 4 stepper motors using 4x A4988 or DRV8825 with this shield and an Arduino you can build all kinds of robotics or CNC projects including CNC routers, laser cutters and even pick&place machines. This is the KIT...
Power and Energy
Pile: lithium; 3V; CR1220; Nb.de piles:5; Ø12x2mm; 35mAh
Widora-AIR V6.0 is an ESP32 (ESP8266 successor with bluetooth) board that is very thin and can be stacked on a breadboard. You can start prototyping you app with bluetooth 4.0 and wifi in a few minutes. Moreover, you can use atom, arduino and other ide to develop for it in a range of languages (C, C++, LUA, Python, etc.)
Chem-Wik® Rosin is especially designed for today’s heat sensitive electronic components. The lighter mass, pure copper braid construction allows for better thermal conductivity, even at low temperatures. Chem-Wik® Rosin responds as much as 50% faster than conventional desoldering braids. This design minimizes overheating and requires less “contact”...
8-Bit Digital-to-Analog Converters
Le premier microcontrôleur Raspberry Pi en silicium avec Puce RP2040 Programmation en C / C ++ et MicroPython Processeur ARM Cortex M0 + double cœur - 133 MHz avec 264 Ko de SRAM et 2 Mo de mémoire Flash intégrée 26 broches GPIO multifonction 2 × SPI, 2 × I2C, 2 × UART, 3 × ADC 12 bits, 16 × canaux PWM contrôlables
5 cm (2") 3W 8 Ohm miniature speaker with a plastic basket and plastic diaphragm. Broad frequency response and good voice reproduction. Particularly well suited to outdoor applications and where ambient conditions are generally unfavourable (e.g. high humidity).
Z80 BOX X:89mm Y:119mm Z:38mm ABS BLACK CASE
The Universal 4 Pin Buckled Cable is made for the Grove System to connect all of the Twigs to the Stem - Basic Shield or to other Twig compatible boards for quick prototyping. As a lot of users ask for different length of cables, so we made the 30cm cables for different applications.
A prototype AA battery case, it has on/off switch on the case, and it can be fully closed by cap and further screw it to close, so it’s very well protected.