DC 12V 100RPM Mini Gear Motor 3mm JA12-N20
Gear (reduction) motor of pretty good quality, running at 100rpm.
All you need to do is connect the postive and negative pole-pin, simple enough for beginners.
- Operating voltage: 12V
- Load current: 50mA
- Diameter: 12mm
- Weight: 11g
- Speed: 100RPM
- Torque: 2.5KG*CM
Customers who bought this product also bought:
This is a simple to use voltage régulator that outputs 3.3V at 1.3A
Highly integrated module popularly used for entry detection, it complies with microcontroller or DC loads.
The reed switch is an electrical switch operated by an applied magnetic field. When the device is exposed to a magnetic field, the two ferrous materials inside the switch pull together and the switch closes. When the magnetic field is removed, the reeds separate and the switch opens. This makes for a great non-contact switch. It consists of a pair of...
This is a 5V 8-Channel Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
Very bright yet low-power rgb led, common anode flavor (easier to use in arrays).
JST 1.25MM wire connector Male and Female pairs
Small but powerfull 360-degrees continuous rotation servo. (38g, 5.5kg/cm, 4.8v-6v)
A prototype AA battery case, it has on/off switch on the case, and it can be fully closed by cap and further screw it to close, so it’s very well protected.
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Capacitive touch switch key module 2.7V-6V module anti-interference strong Arduino