5MM 5800B Photosensitive LED Photo

SENLEDLPHS
Last items in stock
€1.25

5MM 5800B Photosensitive LED Photo

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

--

1 Item
New product
No reviews

Customers who bought this product also bought:

Available
Electronics

Infrared Kit - IR Receiver (HS0038) + IR LED...

IRELDRECTRANS
€0.79
hs0038 IR sensor tuned to 38KHz, perfect for receiving commands from a TV remote control. Runs at 5V (although it seems to be OK down to 3.3V)To use, connect pin 3 (all the way to the right) to 5V power, pin 2 (middle) to ground and listen on pin 1. It doesn’t do any decoding of the signal, just passes the ‘raw data’ along.
2
Available
Electronics

3.3V Low-Cost Laser Pointer - Red Point

LASLCO33V
€1.25
This laser pointer or laser pen is a small handheld device with a laser diode emitting a very narrow coherent low-powered laser beam of visible light, it is frequently used in lecture halls and demonstrations to point at topics of interest on a presentation board. In a school setting, they have become ubiquitous, and they are very useful teaching aids....
2
Available
Electronics

male female splittable jumper wires (200mm, 40...

CONSEDMFP40P20
€4.17
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
2
  • Reduced price / -€5.00
Available
Motorized

4WD Robot Double Smart Car Chassis Kit (ideal...

ROB4WDACR
€20.00 €25.00
A simple mechanical structure, very convenient platform to build upon with 4 DC motors that can be controlled separately. Two levels of acrylic plates to allow for bigger electronics. Very simple assembly.
Available
Dev. Tools

UNO R3 ATmega328 chip (Arduino Compatible )

MCB00003C
€12.50
The Uno is a microcontroller board based on the ATmega328 and compatible with the Arduino Uno R3. It has 14 digital I/O pins, 6 analog inputs, a 16MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or...
Product added to wishlist
Product added to compare.