FT232RL Tiny Breakout (USB FTDI TTL)

USBITD00001B
€5.67

FT232RL breakout. The FT232RL is a USB to serial UART interface with optional clock generator output. It’s the essential tools for establishing communication between PC and mostly MCU. Especially, it’s the optimum tool for basic boards without without USB interface, like arduino pro, colorduino, etc.

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

Basic features 

  • Single chip USB to asynchronous serial data transfer interface. Tiny volume
  • Entire USB protocol handled on the chip – No firmware programming require
  • 5V Single Supply Operation and compatible with 3.3V/5V operation voltage.
  • USB 2.0 Full Speed compatible

6 Items
New product
No reviews

Customers who bought this product also bought:

Available
Dev. Tools

Arduino-Compatible Pro Mini [16M/5V, 8M/3V3]

MCBARDPROMIN
€5.00
The minimal design approach to EDArduino, and fully compatible with arduino. This is a 5V EDArduino running the 16MHz bootloader (select ‘Arduino pro mini′ within the Arduino software). EDArduino Pro Mini does not come with connectors populated so that you can solder in any connector or wire with any orientation you need. We recommend first time EDArduino...
2
Available
Dev. Tools

Foca Pro : FT232RL Tiny Breakout (FTDI USB to...

USBITD00001
€9.17
Foca is a FT232RL breakout. The FT232RL is a USB to serial UART interface with optional clock generator output. It’s the essential tools for establishing communication between PC and mostly MCU. Especially, it’s the optimum tool for basic boards without without USB interface, like arduino pro, colorduino, etc. The good point is that it also supports the...
2
Available
Electronics

GY-BME280 High Precision Atmospheric Pressure,...

SENGYBME280
€10.08
GY-BME280 is a Breakout Board featuring a Bosch Sensortec BME280 Temperature, Humidity & Pressure Sensor. The board has selectable I2C address jumper (solder link GS2), I2C pull-up resistors, 7 pin header 2.54mm, and two mounting holes 3.5mm. Default setting of the board; single power rail Vdd=Vdd_IO (solder link GS1), pull-ups resistors (R2, R3) 10k,...
Product added to wishlist
Product added to compare.