Your cartThere are no more items in your cart
LD1117 / LM1117 - 3.3V LDO Voltage regulator 1.3A TO220ST Microelectronics
This is a simple to use voltage régulator that outputs 3.3V at 1.3A
Customers who bought this product also bought:
no odor finely drilled tough including power pad. Clean hole
8cm x 12cm protoboard with 2.54mm spacing
This adapters allows you to use a VGA monitor on any board with HDMI output. It has been tested on resolutions up to 1920x1080.
Very useful and high quality 0.7mm 100g solder spool for all your needs. Ideal for all kind of work, even high precision ones as the wire is very thin.
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Lithium Polymer Battery -175mAh 3.7V
This is a half-bridge load sensor, which is widely used in weight scales. When the half-bridge is being stretched, it sends signal via the red signal wire. You can use multiple load sensors simultaneously to increase the capacity range.
Jack 3,5mm; female; st, with grommet; straight; for cable
This is a digital temperature sensor, that is already calibrated. The measurement is done where the sensor is, no need for long insulated wire or complicated ADC design. This sensor is therefore also perfect for use with a Raspberry Pi, as it is not analogic, all the data is transmitted in digital One Wire protocol.