Your cart
There are no more items in your cart
Smart LCD Controller For RepRap Ramps 1.4 3D Printer (screen)
RPRJANLCD3DP
Out-of-Stock
€15.00
€50.00
-€35.00
The intelligent controller includes an SD card reader, rotary encoders and a 20-character × 4 line LCD display. .
After connecting this panel to your Ramps you don't need your pc any more, the Smart Controller supplies power for your SD card. Further more, all actions like calibration, axes movements can be done by just using the rotary encoder on the Smart Controller. Print your 3D designs without PC, just with a g-code design stored on the SD card.
Features:
1 large-screen LCD 2004.
2.Back integrated SD card, SD card file into slices on the LCD to select the corresponding document can be printed.
3. Product comes encoder parameter adjustment that can be achieved, and the file select will be print.
New product
No reviews
Customers who bought this product also bought:
Electronics
10 Resistors pack (1/4w, 1 value, carbon film,...
RES10PACK025W
€0.75
A single pack of 10 resistors of the same value, useful for a single project where you need a particular resistor value.
Electronics
SM24240, Two-Phase Stepper Motor (NEMA 17)
STEWS24240
€11.90
€15.00
This is a simple and bi-polar stepper motor, it is what you need for your Reprap, Makerbot and other 3D Printers or CNC or Laser or Plasma cutter
Prototyping
Medium (Basic) Breadboard ( White, 16.5*5.5 cm...
PCB00008
€5.00
Standard size breadboard that is perfect for prototypes. It does even have power rails on the sides to allow for more than one power level. The one you will get is white and not transparent as in the picture.Breadboard
Electronics
Alligator clips test leads set (50cm, 10 wires,...
CONALIGWIRE
€5.50
Color-coded Alligator clips on wires (double ended alligator clip wires)
Electronics
Raspberry Pi Camera 1.3
SENRPICAM
€16.58
The Raspberry Pi Camera Module is a custom designed add-on for Raspberry Pi. It attaches to Raspberry Pi by way of one of the two small sockets on the board upper surface. This interface uses the dedicated CSI interface, which was designed especially for interfacing to cameras. The CSI bus is capable of extremely high data rates, and it exclusively...
Electronics
A4988 stepper motor driver with heat sink...
MDRA4988
€6.25
The A4988 stepper motor driver carrier is a breakout board for Allegro’s A4988 microstepping bipolar stepper motor driver. The driver features adjustable current limiting, overcurrent and overtemperature protection, and five different microstep resolutions (down to 1/16-step). It operates from 8 – 35 V and can deliver up to approximately 1 A per phase...
Electronics
male female splittable jumper wires (200mm, 40...
CONSEDMFP40P20
€4.17
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Electronics
RT9266 DC Step-Up Boost Module 5V, 1A
ENEELDBSTRT9266
€3.33
boost stepup Input voltage from 1-5V, output voltage at 5V.
Simple step-up module to use an lower voltage as a sorce for a circuit needing a higher one at 5V.