STM32L011K4 Ultra-low-power Arm Cortex-M0+ MCU with 16-Kbytes, 32 MHz CPU supports Arduino nano connectivity
€13.90
Tax included
The NUCLEO-L011K4 is a Nucleo-32 development board featuring the ultra-low-power STM32L011K4T6 microcontroller. It lets you prototype and develop new ideas with the STM32 microcontroller, choosing from various combinations of performance, power consumption and features. The board ships with the full STM32 HAL software library and a wide set of embedded software examples, with direct access to online ARM mbed™ resources.
STM32L011K4
- Ultra-low-power platform
- 1.65 V to 3.6 V power supply
- -40 to 125 °C temperature range
- 0.23 μA Standby mode (2 wakeup pins)
- 0.34 μA Stop mode (16 wakeup lines)
- 0.67 μA Stop mode + RTC + 2 KB RAM retention
- Down to 79 μA/MHz in Run mode
- 5 μs wakeup time (from Flash memory)
- 1 μA 12-bit ADC conversion at 10 ksps
- Core: ARM® 32-bit Cortex®-M0+
- Up to 32 MHz max.
- 0.95 DMIPS/MHz
- Ultra-safe, low-power BOR (brownout reset) with 5 selectable thresholds
- Ultralow power POR/PDR
- Programmable voltage detector (PVD)
- Clock sources
- 0 to 32 MHz external clock
- 32 kHz oscillator for RTC with calibration
- High speed internal 16 MHz factory-trimmed RC (+/- 1%)
- Internal low-power 37 kHz RC
- Internal multispeed low-power 65 kHz to 4.2 MHz RC
- PLL for CPU clock
- Pre-programmed bootloader
- USART, SPI supported
- Development support
- Serial wire debug supported
- Up to 38 fast I/Os (31 I/Os 5V tolerant)
- Memories
- Up to 16 KB Flash memory with ECC
- 2 KB RAM
- 512 B of data EEPROM with ECC
- 20-byte backup register
- Sector protection against R/W operation
- Rich Analog peripherals
- 12-bit ADC 1.14 Msps up to 10 channels (down to 1.65 V)
- 2x ultra-low-power comparators (window mode and wake up capability, down to 1.8 V)
- 7-channel DMA controller, supporting ADC, SPI, I2C, USART, Timers
- 5x peripherals communication interface
- 1x USART (ISO 7816, IrDA), 1x UART (low power)
- 1x SPI 16 Mbits/s
- 1x I2C (SMBus/PMBus)
- 8x timers: 1x 16-bit with up to 4 channels, 1x 16-bit with up to 2 channels, 1x 16-bit ultra-low-power timer, 1x SysTick, 1x RTC and 2x watchdogs (independent/window)
- CRC calculation unit, 96-bit unique ID
- All packages are ECOPACK®2
You might also like
The NUCLEO-L011K4 is a Nucleo-32 development board featuring the ultra-low-power STM32L011K4T6 microcontroller. It lets you prototype and develop new ideas with the STM32 microcontroller, choosing from various combinations of performance, power consumption and features. The board ships with the full STM32 HAL software library and a wide set of embedded software examples, with direct access to online ARM mbed™ resources.