Your cart
There are no more items in your cart
M5STICKC IoT Arduino Basic Kit (ESP32-PICO Mini IoT , Wifi, Bluetooth 4, LCD, Battery, etc.)
MCBM5STIKIT
€19.58
M5Stick-C is a mini M5Stack, powered by ESP32. It is a portable, easy-to-use, open source, IoT development board.
What it can do? This tiny block is able to realize your idea, enlighten your creativity, and help with your IoT prototying in a very short time. It will takes away a lot of the pains form the development process.
M5stickC is one of the core devices in M5Stack product series which is built in a continues growing hardware & software ecosystem. It has a lot of compatible modules & units, as well as the open source code & engineering community that will help you maximum your benefit in every step of the developing process.
Notice:
Product Features
- 5V DC power supply
- USB Type-C
- ESP32-based
- 4 MByte Flash + 520K RAM
- 6-Axis IMU SH200Q
- Red LED
- IR transmitter
- Microphone
- 2 Buttons, LCD(0.96 inch), 1 Reset
- 2.4G Antenna: Proant 440
- 80 mAh Lipo Battery
- Extendable Socket
- Grove Port
- Development Platform UIFlow, MicroPython, Arduino
ESP32 Features
- 240 MHz dual core Tensilica LX6 microcontroller with 600 DMIPS
- Integrated 520 KB SRAM
- Integrated 802.11b/g/n HT40 Wi-Fi transceiver, baseband, stack and LWIP
- Integrated dual mode Bluetooth (classic and BLE)
- Hall sensor
- 10x capactive touch interface
- 32 kHz crystal oscillator
- PWM/timer input/output available on every GPIO pin
- SDIO master/salve 50MHz
- SD-card interface support
2 Items
New product
No reviews
Customers who bought this product also bought:
Electronics
Jack 3,5mm 90°(Male stereo, with grommet...
CONBARJACKJC00690
€1.50
Audio Jack 3,5mm; male; stereo, with grommet; straight; for cable 90° audio
Raspberry Pi
4 Port USB HUB HAT for Raspberry Pi
HATRAS4USB
€10.42
4 Port USB HUB HAT for Raspberry Pi
ESP32
C050 ESP32-PICO-D4, Microcontroller M5Stamp...
M5STSTAMPPICO
€5.50
STAMP-PICO features an ultra-compact design with two low-power Xtensa® 32-bit LX6 microprocessors at 240MHz on a PCB as tiny and delicate as a postage stamp. low power consumption. It is ideal for any space-constrained or battery-powered devices such as wearables, medical devices, sensors, and other IoT devices.
Sensors
Official M5Stack ESP32 Core Ink Development...
SENM5SINK
€41.58
Official M5Stack ESP32 Core Ink Development Kit, Industrial Control Panel, IoT E-Book Terminal, 1.54 inch eInk Screen, 390mAh
Power and Energy
4S 6A 16v 18650 BMS PCM protection charge...
ENETAOCHMOB4S
€4.58
4S 6A 16v 18650 BMS PCM protection charge batterie li-ion
ESP32
M5STACK JoyC (W/O M5StickC) Omni-directional...
MCBM5STAJOYC
€15.42
JoyC is a rocker module designed for the M5StickC.It supports two-hand operation. Embedded STM32F030F4 main control chip, using I2C communication protocol and host M5StickC for data transmission. The range of the joystick is 0~200, there are 12 RGB LEDs under the left and right joysticks, and the bottom of the joystick is equipped with a 16340 battery...
Electronic basics
M5stack Grove Ultrasonic Distance Unit (RCWL-9600)
GROVM5SULTR
€4.17
Description
Ultrasonic is an ultrasonic distance measuring sensor unit, with the capability of simultaneous reception and transmission. The ultrasonic probe has a sound frequency of 40KHz, a direction angle of ±20 ° and an accuracy of 1mm. The internal part is calculated by an RCWL-9600 ultrasonic distance measuring chip, and the measurement results can...
Dev. Tools
official joystick M5Stack Stick C Hat STM32F030F4
MCBM5STIJO
€7.50
official joystick M5Stack Stick C Hat STM32F030F4