433Mhz wireless PIR Motion Sensor
€5.58 €16.58 -€11.00
This is a wireless PIR for your home automation project. With its included batteries, just install it on your wall and voilà, a new door motion sensor !
Customers who bought this product also bought:
This protoboard is double sided, meaning that you can easily put components on both sides. It is perfect for all your DIY projects, as with its 0.1" (2.54mm) pitch it fits nearly all the through hole components.
The 433M RF link kit is consisted of transmitter and receiver, popular used for remote control. 433MHz frequency and ASK modulation.
This is a power module for the standard bread boards (Small and Medium sized). It's concave design so will not wast your proto zone. It also supports both 5v and 3.3v (both can be enabled on each power rail). We think it is a must to have on your workbench, really.
With it you enter in resistance.
This is a digital temperature sensor, that is already calibrated. The measurement is done where the sensor is, no need for long insulated wire or complicated ADC design. This sensor is therefore also perfect for use with a Raspberry Pi, as it is not analogic, all the data is transmitted in digital One Wire protocol.
Completed to make your wemos d1 mini nomadic
This is a simple to use voltage régulator that outputs 3.3V at 1.3A
This is a long distance 2.4G wireless module which basic on nRF24L01+ chip, and there is the PA and LNA circuit on board, with the external antenna it can reach long distance than the one without these parts.
Simple 5.0mm 2 pins screw terminal. Can be chained to make longer terminal blocks. This termina can fit perfectly on a breadboard to connect remote peripherals.
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.