Joystick ALPS SKQU 4 direction w/ Switch
Just ass a joystick to any project with the ALPSA SKQU. It's a handy button with a 4 direction joystick in an easy to mount small package.
(5mA 5V DC)
|100,000 cycles for each direction|
|Initial contact resistance||500mΩ max.|
|Minimum packing unit (pcs.)||1,000|
|Operating temperature range||-30°C to +85°C|
|Ratings (max.)/(min.) (Resistive load)||50mA 12V DC/10µA 1V DC|
|Electrical performance||Directional resolution||4-direction|
|Insulation resistance||100MΩ min. 100V DC|
|Voltage proof||250V AC for 1 minute|
|Mechanical performance||Direction application force||1.57(+0.39, -0.69)N|
|Push application force||3.14±0.59N|
|Robustness of terminal||49N for 1 minute|
|Solder heat resistance||Manual soldering||350°C max. 3s max.|
|Dip soldering||260°C max. 5s max.|
|Durability||Vibration||10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the frequencies, in the 3 direction of X, Y and Z for 2 hours respectively|
|Operating life||Directions||100,000 cycles|
|Center push||100,000 cycles|
|Environmental performance||Cold||-30±2°C for 96h|
|Dry heat||80±2°C for 96h|
|Damp heat||60±2°C , 90 to 95%RH for 96h|
More info on product page.
Customers who bought this product also bought:
Those potentiometer are great little tools that can be easily used on your prototypes to enter custom resistor values.
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 ESP12E wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.
3 Meter micro-usb cable. Perfect to connect to your phone, dev board or to power a raspberry pi.
The AD597ARZ is a monolithic temperature Set-point Controller which has been optimized for use at elevated temperatures such as those found in oven control applications. The device cold junction compensates and amplifies a type J or K thermocouple input to derive an internal signal proportional to temperature. The internal signal is then compared with an...
It is suitable for CR2032 lithium coin cell battery. Through Hole Mount
Transistor bipolaire 2N3904, NPN
Nokia 5110 LCD is a low-cost 84*48 pixels graphic LCD. It uses the PCD8544 controller. The PCD8544 interfaces to microcontrollers through a serial bus interface (5-wires).
1.5 Meter micro-usb cable. Perfect to connect to your phone, dev board or to power a raspberry pi.