Your cart
There are no more items in your cart
USB Cable Type A to 5.5mm Barrel Jack Adapter
CONGENUSBBARREL
€4.00
This is a simple adapter from an usb port to a barrel jack connector, very useful for Arduino and other mcu board with a barrel jack adapter.
This is a usefull USB cable for Arduino fanciers - type A to Barrel Jack Adapter. It can be used to power Arduino or Arduino Mega by plugging into USB port of adapter or computer. It's a 100cm cable and long enough for normal use. 5.5mm barrel jack.
12 Items
New product
No reviews
Customers who bought this product also bought:
Tools
ULTIMAX IR-ZD90 30W-130W 240V QUICK HEAT...
TOLIRONSR963
€10.83
Light weight,comfortable general purpose.This series are designed for laboratory,household repair soldering.
Dev. Tools
Foca Pro : FT232RL Tiny Breakout (FTDI USB to...
USBITD00001
€9.17
Foca is a FT232RL breakout. The FT232RL is a USB to serial UART interface with optional clock generator output. It’s the essential tools for establishing communication between PC and mostly MCU. Especially, it’s the optimum tool for basic boards without without USB interface, like arduino pro, colorduino, etc.
The good point is that it also supports the...
Sensors
DHT-22 Temperature & Humidity Sensor
SENDHT22
€6.25
€8.25
The DHT-22 is a low cost humidity and temperature sensor with a single wire digital interface. The sensor is calibrated and doesn't require extra components so you can get right to measuring relative humidity and temperature.
Home
Micro USB male to USB A Female (for USB OTG)
CONUSBMICUSBFEM
€4.00
Simple plug to connect standard usb devices to your smartphone, tablet, or dev board with a compatible micro usb port.
ESP32
Widora-AIR ESP32 module WIFI V6 version...
WIRNODMCUAIR
€11.40
€17.50
Widora-AIR V6.0 is an ESP32 (ESP8266 successor with bluetooth) board that is very thin and can be stacked on a breadboard. You can start prototyping you app with bluetooth 4.0 and wifi in a few minutes. Moreover, you can use atom, arduino and other ide to develop for it in a range of languages (C, C++, LUA, Python, etc.)
Electronics
Micro Booster (Micro USB or solder pads,...
ENEJANBSTMUSB
€2.58
The module supports MicroUSB input, a USB charger or mobile power supply can easily get to it 9V, 12V, 15V, 18V, 24V, easy to use. Wide input and output voltage, high conversion efficiency.
Electronics
1 Channel 5V Relay Module (5V, 250VAC/10A)
REL1CH5V
€2.67
€4.17
This is a 5V 1-Channel Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
Electronics
3.3V/5V Logic Level Converter (2-channel...
ADATXRX335
€2.42
If you’ve ever tried to connect a 3.3V device to a 5V system, you know what a challenge it can be. This logic level converter is a small device that safely steps down 5V signals to 3.3V and steps up 3.3V to 5V. This level converter also works with 2.8V and 1.8V devices. Each level converter has the capability of converting 4 pins on the high side to 4...
Electronics
10 Resistors pack (1/4w, 1 value, carbon film,...
RES10PACK025W
€0.75
A single pack of 10 resistors of the same value, useful for a single project where you need a particular resistor value.
Electronics
Dual male splittable jumper wires (200mm 40...
CONSEDJMP40P20
€4.17
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.