28BYJ-48 High quality Stepper motor 12V
€3.50 €7.00 -€3.50
Mainly used in Air Conditioner Louver , Small Cooling/Heating Fan etc., Stable and all technic parameters are qualified for national electronic standard of SJ/T10689-95
- Rated voltage 12VDC
- Number of Pole 4
- Speed Variation Ratio 1/64
- Stride Angle 5.625° /64
- DC resistance 200Ω±7%(25℃)
- Idle In-traction Frequency >600Hz
- Idle Out-traction Frequency >1000Hz
- In-traction Torque >34.3mN.m(120Hz)
- Self-positioning Tor >34.3mN.m
- insulated resistance >10MΩ(500V)
- insulated electricity power 600VAC/1mA/1s
- Insulation grade A
- Rise in Temperature <40K(120Hz)
- Noise <40dB(120Hz,No load,10cm)
Customers who bought this product also bought:
RepRap 3D Printer Synchronous Belt 28Teeth Round Timing Pulley
Photo-interrupter to sense when an object is close (if read as digital), and how close it is (if read as analog), in very near range.
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Half size breadboard that is perfect for small prototypes. It does even have power rails on the sides to allow for more than one power level.
barrel jack This is a DC Jack 5.5/2.1 to screw terminals adapter. It is ideal to connect standard power supplies to your project, led panels, strips or whatever.
The test hooks are spring loaded hook.
This solenoid in particular is strong, and has a slug with a slanted cut and a good mounting bracket. It's basically an electronic lock, designed for safe or door.
MF RC522 is a highly integrated transmission module for contactless communication at 13.56 MHz. This transmission module utilises an outstanding modulation and demodulation concept completely integrated for different kinds of contactless communication methods and protocols at 13.56 MHz.
Dual stepper motor driver shield can drive 2 stepper motors at the same time by Arduino. It can work with the power supply from 4.75V to 30V. High accuracy controlling can be supported by Arduino for CNC milling machine.