20mm square 8x8 LED Matrix - Red
This is a very small yet powerful led matrix, in red color.
Voltage to apply : 3.3v. Always use it with correct resistors or you will burn the leds.
ABCDEFGH Connect to Anode Power.
12345678 Connect to Cathode Power.
- Zone de stockage
- Résolution d'affichage
- Etage de rangement
- Compatibilité avec les cartes
- Adresse de la page produit fabricant
- Tension en entrée
- Type de composant
- Google Product Type
- Display Type
- Colonne de rangement
- Code Fabricant
- Prix d'achat
- Mémoire Flash (programme)
Customers who bought this product also bought:
The Arduino Mega 2560 is a microcontroller board based on the ATmega2560 (datasheet). It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the...
Simple 5mm yellow led with 20mcd power.
You can simply plug this USB Wifi dongle into the USB port of your Dev Board and you're ready to connect to a nearby wireless network with extra power thanks to its antenna.
no odor finely drilled tough including power pad. Clean hole
With compact design, the board can integrate the real-time clock module DS1307, EEPROM memory AT24C32 and digital temperature sensor DS18B20 (not supplied on the board) which are connected via I2C bus together on a 27mm*28mm*8.4mm board.
TI's MSP430 Launchpad board is a perfect start in the MSP430 family with the value line chips (msp430g2xxx). With the fact that you an easily remove the chip to put in your own circuit or program nearly all the msp430f2xxx and msp430g5xxx chips, it makes for a great project factory at a very low price. Also, the pack comes with two micro-controllers (you...
High power mosfet to switch all your devices/leds/motors easily. This is the P-type, meaning you have to put it between the load and the ground.
Standard size breadboard that is perfect for prototypes. It does even have power rails on the sides to allow for more than one power level. The one you will get is white and not transparent as in the picture.
It's a small breakout board for the ENC28J60 Ethernet chip. Contains all the necessary hardware to implement an Ethernet interface including the isolation transformer and LINK/STATUS and power LEDs. SPI interface makes this one of the easiest 10Base-T ICs yet. It's 3.3V with 8KB buffer.
Simple 5mm red led with 25mcd power.