Your cartThere are no more items in your cart
Raspberry Pi Prototype PCB Board
A basic prototyping board for raspberry pi, fundamental and useful.
- Raspberry Pi Prototype board.
- All the pins lead out.
- Connected soldering pin holes, similar as prototype breadboard
- one side 3V and GND, one side 5V and GND power channels.
- On board reserved EEPROM design.
- Package includes the bare PCB board only, and 2x20P pin header.
Customers who bought this product also bought:
E-ink, E-paper 2.13” Raspberry Pi Module
A 10k ohm horizontal Logarithmique potentiometer for all your audio and other projects.
This is a 90 degree angle male header, very useful for a lot of things, including to plug boards like the arduino on your protoboards.
Soil moisture module is most sensitive to the ambient, generally used to detect the moisture content of the soil.When the module can not reach the threshold value, DO port output high, when the the soil humidity exceeds a set threshold value, the module D0 output low;The small board digital output D0 can be connected directly to the MCU, MCU to detect...
The STM32VLDISCOVERY is a low-cost and quick way to discover the STM32 value line. It includes everything required for beginners and experienced users to get started quickly. The STM32 value line Discovery includes an STM32F100 value line microcontroller in a 64-pin LQFP and an incircuit ST-Link debugger / programmer to debug Discovery applications and...
This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for...
Simple 5mm red led with 25mcd power.
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
The 433M RF link kit is consisted of transmitter and receiver, popular used for remote control. 433MHz frequency and ASK modulation.