Linux

2
Out of stock
Outils de dev.

Radxa Rock Pro - Mini carte ARM Quad Core...

LINRADXAROCKPRO
107,50 €
Radxa’s new product for single-board computers. The CPU is ARM Cortex-A9 processor running from 324Mhz to 1.6Ghz, and can balancing between performance and power saving. It integrate with full interfaces, all ways to connect like Wifi, Bluetooth, HDMI, USB, Spdif, MIC and TF Card.   As a barebones single-board computer, the key feature for 80 pins 2.54mm...
View
2
Out of stock
Cartes officielles

Arduino Yún (Arduino, Linux and WiFi in one...

Arduino
MCBARDYUN
60,00 €
The Arduino Yún is a microcontroller board based on the ATmega32u4 (datasheet) and the Atheros AR9331. The Atheros processor supports a Linux distribution based on OpenWRT named Linino. The board has built-in Ethernet and WiFi support, a USB-A port, micro-SD card slot, 20 digital input/output pins (of which 7 can be used as PWM outputs and 12 as analog...
View
2
Out of stock
Outils de dev.

Intel GalileoV2 Arduino Developement Board...

Arduino
MCBARDGALI
62,50 €
Galileo V2 is a microcontroller board based on the Intel® Quark SoC X1000 Application Processor, a 32-bit Intel Pentium-class system on a chip (datasheet). It’s the first board based on Intel architecture designed to be hardware and software pin-compatible with Arduino shields designed for the Uno R3. Digital pins 0 to 13 (and the adjacent AREF and GND...
View
2
Out of stock
Outils de dev.

NanoPi M1 (Quad Core A7 ARM, 512M RAM)

LINNANPIM1
18,33 €
Quite nice little ARM quad-core board at a very low price. It even features an ethernet port, three USBs, an infrared receiver and an HDMI port.
View
2
Out of stock
Outils de dev.

NanoPi M1 (Quad Core A7 ARM, 1GB RAM)

LINNANPIM11GB
22,00 €
Quite nice little ARM quad-core board at a very low price. It even features an ethernet port, three USBs, an infrared receiver and an HDMI port.
View
2
  • Prix réduit / -2,55 €
Available
Outils de dev.

USB Wifi Miniature dongle (pcDuino, Raspberry...

WIRMINUSBWIF
8,75 € 11,30 €
You can simply plug this USB Wifi dongle into the USB port of your Dev Board and you're ready to connect to a nearby wireless network!
2
Out of stock
Electronique

Raspberry PiGPIO Triple Expand Board

GPIORPITEB
18,75 €
The Raspberry Pi GPIO Triple Expand Board converts the single GPIO header on the Raspberry Pi B+/A+ into three, and enables the addition of breakout boards, add-on boards or just about anything that's designed to connect on to a Raspberry Pi B+/A+ GPIO!
View
2
Out of stock
NanoPi

NanoPi M3 (Octa Core Cortex A53 1.4GHz, 1GB...

LINNANPIM3
53,75 €
The NanoPi M3 is another ARM board developed by FriendlyARM for makers, hobbyists and hackers. With this new friend we wish you could get not only tech skills but also unique experiences in various applications and hacking. It is small, elegant but has rich ports and interfaces. Playing with it and working with it the M3 will not only inspire your ideas...
View
2
Available
Outils de dev.

Seeeduino Cloud - Compatible Arduino Yun (Carte...

MCBSEDCLOUD
55,00 €
Seeeduino Cloud is a microcontroller board based on Dragino WiFi IoT module HE and ATmega32u4. HE is a high performance, low cost 150M, 2.4G WiFi module which means “core” in Chinese and with an Open Source OpenWrt system inside. Seeeduino Cloud is also an Arduino compatible board, 100% compatible to grove, shield and IDEs(>=1.5.3). Except for the...
2
Out of stock
Outils de dev.

Raspberry Pi Night Vision Camera Light Sense IR...

SENRPIIRLED
7,50 €
On board photoresistor, on board adjustable resistor; Operation: connect LED board and PCB board of camera w/ screw, adjust resistor of LED board (IR light auto work when it is dark and auto off if it is bright)
View
2
Available
Outils de dev.

RPI GPIO Shield (Arduino Layout, Logic Volt...

PCBRPIBRI
11,00 €
If you are an expert but just step into raspberry pi, this item will create a good bridge for your learning purpose. All the Raspberry pi pins are “redefined” into arduino style pins, so you can focus on python programming and higher level controlling by using RPI.
2
Out of stock
Outils

Raspberry Pi B+/2/3 Enclosure - Transparent /...

CASRPI2CLR
6,25 €
It is a good plastic box for Raspberry Pi, which can protect it with one of these snazzy plastic enclosures?. These cases protect the Raspberry Pi from things like rogue wires that might short it out while still allowing full access to the board! Simply snap the RPi into the bottom half of the enclosure, then snap the two sides together.
View
2
  • Prix réduit / -30,00 €
Out of stock
Outils de dev.

Raspberry Pi 5” LCD Display HDMI w/touch 800×480

LCDRPI5TCH
45,00 € 75,00 €
Very nice display compatible with Raspberry Pi 3 B, 2 B, 1 A+ and B+. It fits easily and has a very good response time thanks to its HDMI interface. This is the only one we've seen to boast this interface while still being a plug-in cape/shield. Setup time is quite fast, you just have to set the resolution in the config.txt of your raspberry pi and voilà...
View
2
Available
Prototypage

Platine de prototypage pour Cubieboard Proto...

PCBCUBPRO
11,25 €
Cette platine de prototypage pour Cubie Boarrd et Cubie Board 2 vous permettra d'utiliser les composants et connecteurs standards en 2.54mm dans vos projets ainsi que de disposer d'une sortie VGA.
2
  • Prix réduit / -3,25 €
Out of stock
Outils de dev.

BeagleBone Green (Seeed Studio version)

Seeed Studio
LINSEDBBGRN
46,75 € 50,00 €
SeeedStudio BeagleBone Green (BBG) is a joint effort by BeagleBoard.org and Seeed Studio. It is based on the open-source hardware design of BeagleBone Black and developed into this differentiated version. The BBG has included two Grove connectors, making it easier to connect to the large family of Grove sensors. It has also updated the 5V barrel to micro...
View
2
Out of stock
Outils de dev.

Raspberry PI LCD1602 Add-on

iTeadStudio
LCDRPI1602SHIELD
12,00 €
Raspberry PI LCD1602 Add-on is customized for Raspberry Pi interfaces based on LCD1602 display module.
View
Available
Connecteurs et Fils

USB to TTL (UART) Cable

CONCBBUSBTTLCAB
8,08 €
USB to TTL Cable, specialized for dev boards. 5V et 3.3V
2
Available
Outils de dev.

BeagleBone Black (Rev. C)

LINBEAGLEBONEBLK
55,83 €
BeagleBone Black is the newest member of the BeagleBoard family and is a lower-cost, high-expansion focused BeagleBone, featuring the Sitara AM3359 ARM Cortex-A8 32-Bit RISC microprocessor from Texas Instruments. It is similar to the BeagleBone but with some previous features removed to make way for the excellent new features.
2
Available
Electronique

USB Wifi dongle with Antenna (pcDuino,...

WIRANTUSBWIF
14,00 €
You can simply plug this USB Wifi dongle into the USB port of your Dev Board and you're ready to connect to a nearby wireless network with extra power thanks to its antenna.
2
Out of stock
Electronique

Prototype Shield for Raspberry Pi

PCBRPIPROTO
8,33 €
Prototype Shield for Raspberry Pi is a prototype board that you can combine your raspberry pi with other components, modules. As a prototype board, it also provides power and state indicator light. Besides. Note: not include Raspberry Pi
View
Linux
Product added to wishlist
Product added to compare.