Your cartIl n'y a plus d'articles dans votre panier
TP4056 Lithium Battery Charging Board battery protection R3, 1A LIPO
The TP4056 is a complete constant-current/constant-voltage linear charger for single cell lithium-ion batteries.
- Based on old version, but added battery protection IC DW01+8205, over voltage, over current double protection.
- Support output 4.2V to use and charging battery in the same safely.
- Output to load port on right bottom, charge to battery port on right top.
- Micro USB charge port, two LED red indicator
- standby – top right
- charging – top left
- Back side XH2.54 connector for battery.
- Input voltage: 5V, charge input better can provide over 1A current, otherwise not good performance.
- Charge cut-off voltage: 4.2V ± 1%
- Maximum charge current: 1000mA
- Battery discharge protection over voltage: 2.5V
- Battery overcurrent protection current: 3A
Les clients qui ont acheté ce produit ont également acheté...
Outils de dev.
FT232RL breakout. The FT232RL is a USB to serial UART interface with optional clock generator output. It’s the essential tools for establishing communication between PC and mostly MCU. Especially, it’s the optimum tool for basic boards without without USB interface, like arduino pro, colorduino, etc.
JST 1.25MM wire connector Male and Female pairs
Lithium Battery Charge and 5V Boost Board
This is a simple male header, very useful for a lot of things, including to plug boards like the arduino on your protoboards.
Seeking for a GPS module with high quality to complete your electronic works? This GY-GPS6MR2 GPS APM2.5 3-5V Module with Antenna is an ideal choice! Adopting high-level electronic components, it is of high accuracy and can react to your operation timely and precisely. The considerate design makes it easy to install and operate. Moreover, with premium...
0,70 € 1,50 €
Simple 5mm green led with 20mcd power.
Outils de dev.
The minimal design approach to EDArduino, and fully compatible with arduino. This is a 5V EDArduino running the 16MHz bootloader (select ‘Arduino pro mini′ within the Arduino software). EDArduino Pro Mini does not come with connectors populated so that you can solder in any connector or wire with any orientation you need. We recommend first time EDArduino...
Puissance et Energie
The LiPo Charger is extremely affordable and easy to use. No programming is required. Plug it in and it works. The internal charger IC handles all the power flow between the various components.
LEDs & Lampes
5MM Round Blue Led Indicator Light-emitting Diode Lamp