Chainable RGB LED Twig is based on P9813 chip which is a full-color light source LED driver chip, can provide constant current drive and modulated output of 256 gray. Transmission by wire (DATA and CLK), built-in recycling, can enhance the transmission distance.
Tous nos produits sont livrés depuis Paris.
Un doute sur votre achat ? Retournez-nous le produit sous 7 jours et nous vous remboursons.
Nous choisissons et testons minutieusement les produits que nous vendons pour vous proposer uniquement le meilleur.
Chainable RGB LED Twig is based on P9813 chip which is a full-color light source LED driver chip,can provide constant current drive and modulated output of 256 gray. Transmission by wire (DATA and CLK), built-in recycling, can enhance the transmission distance.
Please visit seeed studio'swiki page for more info about this product. It will be appreciated if you can help us improve the documents, add more demo code or tutorials.
Les clients qui ont acheté ce produit ont également acheté...
GY-BME280 is a Breakout Board featuring a Bosch Sensortec BME280 Temperature, Humidity & Pressure Sensor. The board has selectable I2C address jumper (solder link GS2), I2C pull-up resistors, 7 pin header 2.54mm, and two mounting holes 3.5mm. Default setting of the board; single power rail Vdd=Vdd_IO (solder link GS1), pull-ups resistors (R2, R3) 10k,...
This kit is used for one way wireless communication at a frequency of 433MHz and includes a transmitter module and a receiver module. The twig configuration of this kit allows for around 40 meters of transmitting distance indoors, or around 100 meters outside.
It's a small USB to TTL serial tool, using the PL2303 chip.
You can use it to connect some serial device to your PC via USB port, an avr, an msp430 or an stm32 for example.
It's very cheap compared to the ft232 alternative and works very well, up to more than 1mbit/s.
This is one of the greatest kits available for the ESP32. Gives you a nice polished enclosure, a back module with connectors and a small battery, an usb type c cable and jumper wires. If you need to have a nice one shot product or a polished prototype using wifi and/or bluetooth, this is the kit you need. With the protoboards (not included) and upcoming...