3.7V 2900mAh Li-Ion 18650 Battery (3.2V-4.2V, Panasonic, NCR18650PF, LiNiCOMnO2 chemistry)
Nice little battery that is really inexpensive for the (quite high) power it provides. Be sure to use it with a proper holder.
- Capacity Std.
- charge / discharge Nominal 2,900mAh (C nom )
- Minimum 2,750mAh (C min )
- Nominal Voltage
- Average 3.7V
- Standard Charge
- Constant current 1925mA
- Constant voltage 4.2V
- End current(Cut off) 50mA
- Max. Charge Current
- Max. Discharge Current for continuous discharge 2C / 6A (peak 10A)
- Weight Approx. Max. 46.5g
- Operating Temperature
- Charge 0 ~ 45°C
- Discharge -20 ~ 60°C
- Storage -20 ~ 50°C
- Energy density
- Volumetric: 577 Wh/l
- Gravimetric: 214 Wh/kg
Les clients qui ont acheté ce produit ont également acheté...
Nice little case shipped as a kit for your Arduino.
Very bright yet low-power rgb led, common anode flavor (easier to use in arrays).
Outils de dev.
DHT Pro Shield is a digital temperature and humidity sensor shield based DHT22.
he Grove - Gas Sensor(MQ2) module is useful for gas leakage detection (home and industry). It is suitable for detecting H2, LPG, CH4, CO, Alcohol, Smoke or Propane. Due to its high sensitivity and fast response time, measurement can be taken as soon as possible. The sensitivity of the sensor can be adjusted by potentiometer.
Little wireless usb keyboard with embedded touchpad.
Simple step-down module to use an higher voltage as a sorce for a circuit needing a lower one.
JST 1.25MM wire connector Male and Female pairs
This is a digital temperature sensor, that is already calibrated. The measurement is done where the sensor is, no need for long insulated wire or complicated ADC design. This sensor is therefore also perfect for use with a Raspberry Pi, as it is not analogic, all the data is transmitted in digital One Wire protocol.
A prototype AA battery case
Puissance et Energie
With spring load design, you can easily to put the battery in it.