Your cartIl n'y a plus d'articles dans votre panier
Lithium battery cr 2032 Maxell
Pile: lithium; 3V; CR2032,pastille Ø20x3,2mm
Pile: lithium; 3V; CR2032,pastille; Ø20x3,2mm
Les clients qui ont acheté ce produit ont également acheté...
Outils de dev.
The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 4KB ISP flash memory, 256-Byte EEPROM, 256B SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter,...
4,50 € 7,50 €
This is a power module for the standard bread boards (Small and Medium sized). It's concave design so will not wast your proto zone. It also supports both 5v and 3.3v (both can be enabled on each power rail). We think it is a must to have on your workbench, really.
This is a simple to use sound amplifier for your projects.
Nice cable with a good section, when you need more power.
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Circuits intégrés (Chips, puces, ICs)
Simple and powerful op-amp for your projects.
Senses when a door or window is open or closed... Perfect for use with your favourite micro controller board (be it arduino, launchpad, stm3é or whatever) !
The RTC module is specifically designed for Raspberry Pi. It communicated with Raspberry Pi through I2C bus. There is a Maxim DS1307 and CR1220 button cell on the board to keep the real time for a long time after the Raspberry Pi has its power down. Set a serial port, TTL convenient way online debugging.
no odor finely drilled tough including power pad. Clean hole