- Motorisé
- Outils
-
Outils de dev.
-
Electronique
-
Puissance et Energie
- Connecteurs et Fils
- Grove
- Périphériques USB
- Moteur et servo-moteurs
- LEDs & Lampes
- Assembly kits
- Domotique
- Break-out Boards
- Réseau
- Bases de l'électronique
- Circuits imprimés (PCB)
- Son
- Circuits intégrés (Chips, puces, ICs)
- Connectivité sans fil
- Senseurs
- Interface Homme-Machine
- CMS / SMD
- Autres
-
Puissance et Energie
- Prototypage
STLink V3 - Mini Emulator Downloader Programming Unit STM32
12,00 €
TTC
STLINK-V3MODS is a STLINK v3 compact in-circuit debugger and programmer for STM32. It is a mini debugger and programmer for STM32 microcontroller. The JTAG/SWD interfaces are used to communicate with any STM32 microcontroller located on an application board. STLINK-V3MODS also provides a virtual COM port interface enabling the host PC to communicate with the target microcontroller through one UART, and bridge interfaces (SPI, I²C, CAN, and GPIOs) simplifying, for instance, the field programming through the bootloader. STLINK-V3MODS is ready to be embedded in a controller application and can be directly soldered on the PCB motherboard.
- Self-powered through a USB micro-B connector
- USB 2.0 high‑speed compatible interface
- 5V source output capability upto 200mA
- 3.0 to 3.6V application voltage support and 5V tolerant inputs
- JTAG communication support, SWD and SWV (serial wire viewer)
- 3.0 to 3.6V application voltage support on the UART interface and 5V
- VCP frequency upto 15MHz
- 3.0 to 3.6V application voltage support and 5V tolerant inputs
- Drag-and-drop flash programming
- Two colour LEDs: communication and power
Avertissements
Vous aimerez aussi
STLINK-V3MODS is a STLINK v3 compact in-circuit debugger and programmer for STM32. It is a mini debugger and programmer for STM32 microcontroller. The JTAG/SWD interfaces are used to communicate with any STM32 microcontroller located on an application board. STLINK-V3MODS also provides a virtual COM port interface enabling the host PC to communicate with the target microcontroller through one UART, and bridge interfaces (SPI, I²C, CAN, and GPIOs) simplifying, for instance, the field programming through the bootloader. STLINK-V3MODS is ready to be embedded in a controller application and can be directly soldered on the PCB motherboard.