DC 6V 2000RPM Mini moteur à engrenages métal 3mm JA6-N20
Gear (reduction) motor of pretty good quality, running at 2000rpm.
All you need to do is connect the postive and negative pole-pin, simple enough for beginners.
- Operating voltage: 6V
- Load current: 50mA
- Diameter: 12mm
- Weight: 11g
- Speed: 2000RPM
- Torque: 2.5KG*CM
Les clients qui ont acheté ce produit ont également acheté...
This Thumb Joystick is similar to the 'analog' joystick on PS2 (PlayStation 2) controllers. The X and Y axes are two ~10k potentiometers which control 2D movement by generating analog signals. The joystick also has a push button that could be used for special applications.
This motor with small size and less weight, low power. It can output enough force to make some model like mini aircraft and robot platform.
Using sensors L3G4200D, ADXL345, HMC5883L and BMP180, this 10 degrees of freedom IMU will add a whole new world of sensing to your new project.
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Mini USB Nano V3.0 ATmega328P 5V 16M Micro Controller Board CH340 Chip For Arduino
Outils de dev.
The shield is designed based on esp8266 by Espressif Systems, pin-compatible with Arduino UNO/Mega2560 DevBorad. WiFi module is industrial-grade chips ESP8266, which is ESP-12E with metal shield, strong anti-interference ability; Shield is pin-compatible with Arduino Uno, Mega2560 and other control board. A voltage converter chip is used to deal with 3.3V...
Very useful kit of nylon screw, nuts and spacers.
Puissance et Energie
This is a simple to use voltage régulator that outputs 5V at 1.3A
Outils de dev.
The Uno is a microcontroller board based on the ATmega328 and compatible with the Arduino Uno R3. It has 14 digital I/O pins, 6 analog inputs, a 16MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or...
Nice biped kit that has all the mechanical fixtures you need to create your own biped robots.