Your cartIl n'y a plus d'articles dans votre panier
Horizontal Potentiometer (6mm shaft / 10mm length, 10k, Logarithmique)
A 10k ohm horizontal Logarithmique potentiometer for all your audio and other projects.
- Total resistance: 10kΩ
- Rotation angle: 280
- Type: Logarithmique
- Max V: 20VDC
- Actuator Length: 15mm
- Center detent: no
Les clients qui ont acheté ce produit ont également acheté...
Outils de dev.
7,90 € 10,00 €
The Uno is a microcontroller board based on the ATmega328 and compatible with the Arduino Uno R3. It has 14 digital I/O pins, 6 analog inputs, a 16MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or...
10,00 € 14,00 €
Digital RGB LED Flexi-Strip is an intelligent light source consist s of WS2812B RGB LED with Integrated Driver Chip. The control circuit and RGB chip are integrated in a package of 5050 components. This LED flexible strip is a full-color that external control for each lamp beads. It with high brightness, can achieve effects of full color running water,...
One Remote to rule them all.
High power mosfet to switch all your devices/leds/motors easily. This is the N-type, meaning you have to put it between the load and the ground.
Outils de dev.
The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 8KB ISP flash memory, 512B EEPROM, 512-Byte SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter,...
Small but powerfull 360-degrees continuous rotation servo. (38g, 5.5kg/cm, 4.8v-6v)
The 6x AA Battery Holder puts a nice finishing touch on your battery powered project.
The 2xAAA Battery Holder puts a nice finishing touch on your battery powered project. It can provide about 3V(2x1.5V) Voltage power for your project. It is series connection.
Our another great Step-up Module, input from 0.9-5V, output 5V for many digital devices, so this is really a great module for designing a portable charger.
2,45 € 3,75 €
Mini size breadboard, perfect to embed in very small prototypes or to put on an arduino shield.