Infrared Kit - IR Receiver (HS0038) + IR LED transmitter

IRELDRECTRANS
0,79 €

IR sensor tuned to 38KHz, perfect for receiving commands from a TV remote control. Runs at 5V (although it seems to be OK down to 3.3V)To use, connect pin 3 (all the way to the right) to 5V power, pin 2 (middle) to ground and listen on pin 1. It doesn’t do any decoding of the signal, just passes the ‘raw data’ along.

Vous aimerez aussi

Nos engagements
  1. Tous nos produits sont livrés depuis Paris.
  2. Un doute sur votre achat ? Retournez-nous le produit sous 7 jours et nous vous remboursons.
  3. Nous choisissons et testons minutieusement les produits que nous vendons pour vous proposer uniquement le meilleur.

Kit Includes:

  • Universal IR receiver (HS0038) *
  • IR LED transmitter *
  • Size: square, 7mm by 8mm detector area
  • Output: 0V (low) on detection of 38KHz carrier, 5V (high) otherwise
  • Sensitivity range: 800nm to 1100nm with peak response at 940nm. Frequency range is 35KHz to 41KHz with peak detection at 38KHz
  • Power supply: 5V DC 3mA
19 Produits
Nouveau produit
No reviews

Les clients qui ont acheté ce produit ont également acheté...

2
Available
Outils

SR-963 Fer à souder (40W, 220-240V)

TOLIRONSR963
8,33 €
Light weight,comfortable general purpose.This series are designed for laboratory,household repair soldering.
  • Prix réduit / -2,08 €
Available
Electronique

Convertisseur HDMI vers VGA

ADAHDMIVGA
12,50 € 14,58 €
This adapters allows you to use a VGA monitor on any board with HDMI output. It has been tested on resolutions up to 1920x1080.
Available
Outils

Chem-Wik® Rosin Size 100 10-5L 5ft/1.5m 0.76

REMSOLCHWIK
2,50 €
Chem-Wik® Rosin is especially designed for today’s heat sensitive electronic components.  The lighter mass, pure copper braid construction allows for better thermal conductivity, even at low temperatures.  Chem-Wik® Rosin responds as much as 50% faster than conventional desoldering braids.  This design minimizes overheating and requires less “contact”...
2
Available
Electronique

Dual male splittable jumper wires (300mm, 40...

CONSEDJMP40PMM
5,00 €
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
2
  • Prix réduit / -4,17 €
Available
Electronique

L298 Dual H-Bridge Motor Driver

SESMOT103B1M
8,33 € 12,50 €
If you are building a robot with wheels, you need a dual H-Bridge driver like this one. Double H driver module uses ST L298N dual full-bridge driver, an integrated monolithic circuit in a 15- lead Multiwatt and PowerSO20 packages. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive...
2
Available
Electronique

433Mhz Wireless Serial Transceiver Module - 40...

SEDSERTRAN40M
10,00 €
Serial transceiver module is a low cost, high performance transparent FSK transceiver with operating at 434 MHz. It features small size, high output power, high sensitivity, long transmission distance and high communication data rate with auto set up for communication change and data receiving and transmission control.
2
Available
Electronique

NE556N (2 X Timers bipolaires 555) (DIP)

ELCNE556N
0,70 €
The 556 Dual Monolithic timing circuit is an highly stable controllers capable of producing accurate time delays or oscillation. The 556 is a dual 555. Timing is provided by an external resistor and capacitor for each timing function. The two timers operate independently of each other, sharing only VCC and ground. The circuits may be triggered and reset...
Available
Connecteurs et Fils

USB to TTL (UART) Cable

CONCBBUSBTTLCAB
8,08 €
USB to TTL Cable, specialized for dev boards. 5V et 3.3V
Product added to wishlist
Product added to compare.