Your cartThere are no more items in your cart
DHT-12 Humidity Temperature Sensor
This is upgradation version of DHT-11 humidity temperature sensor, fully downward compatible, more precise and add I2C interface.
- Super compact size
- Super low power consumption
- Super low voltage operation
- Standard I2C and 1-wire interface.
- Semi conductor technology
- Sensing range
- Temperature: -20 ~ +60 C
- Humidity: 20-95 RH
- Resolution: 0.1%RH
- Repeat: -+ 1%RH
- Precision 25C @ -+5RH
- Resolution: 0.1C
- Repeat: -+0.2C
- Precision: 25C @ -+0.5C
- Power: DC 2.7-5.5V
- Normal current 1mA
- Standby current 60uA
- Sample cycle: > 2 seconds
- Pin interface: 1. VDD 2. SDA 3. GND 4. SCL (connect to GND when use as 1-wire)
- Colonne de rangement
- Type de composant
- Tension en entrée
- Display Type
- Résolution d'affichage
- Zone de stockage
- Compatibilité avec les cartes
- Etage de rangement
- Vitesse d'horloge
- Mémoire Flash (programme)
- Couleurs d'affichage
- Google Product Type
Customers who bought this product also bought:
USB Connector, MICRO USB F, USB 2.0, Receptacle, 4 Way
The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 8KB ISP flash memory, 512B EEPROM, 512-Byte SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter,...
Switches and Buttons
It’s self push locking switch, push once to lock it, and then push once again to unlock it.
This aplifier allows you to use weight sensors of all kinds.
no odor finely drilled tough including power pad. Clean hole
Photo-interrupter to sense when an object is close (if read as digital), and how close it is (if read as analog), in very near range.
Small Sealed Membrane 4X4 button pad with sticker
Advanced and powerful (100W) step-up module that shows the output voltage (no need for a voltmeter to check it).
Simply the interface of 1602 to IIC, save more IOs, with this board you only need two IOs. This board is also supporting 2004A which is also available in our store.
Those potentiometer are great little tools that can be easily used on your prototypes to enter custom resistor values.