IE Shield (Ethernet ENC28J60 and SD Card) for Arduino (Arduino Compatible)

ASHITEIESHIELD
25,00 €
IE shield is a Ethernet shield which use the ENC28J60 chip for Arduino. It integrates one Micro-SD card slot and provides main interface breakout. You can use it with Arduino to build your Ethernet development platform.

IE shield is an Ethernet Shield instantly enables internet connectivity for Arduino projects with ethernet controller ENC28J60.  Just stack it onto an Arduino to create your own networked devices. Easily check connection status with on board indicator lights. Extend your design further with many Electronic / Sensor  brick interface and an TF card socket.

This Ethernet shield support the POE function, you can use use the twisted-pair to power it and the Arduino board below, instead using the USB prower or external power jack supply. If your router or moden don't support POE, then you can use the injector cable to mix the signale and power for POE supply.

Features

  • IEEE 802.3 compatible
  • Supports POE*
  • Integrated MAC and 10BASE-T PHY
  • Receiver and collision squelch circuit
  • Supports one 10BASE-T port with automatic polarity detection and correction
  • Supports Full and Half-Duplex modes
  • Programmable automatic retransmit on collision
  • Programmable padding and CRC generation
  • Programmable automatic rejection of erroneous packets
  • Two programmable LED outputs for LINK, TX, RX, collision and full/half-duplex status
  • Supports Micro-SD card with SPI operation
  • Much analog and digital interfaces breakout include AD/DA/PWM/UART/IIC/GPIO

Hardware

IE sheild

Interface

Pin

Description

UART

1

5V supply.

2

Ground

3

Tx

4

Rx

GPI

1

5V supply.

2

Digital input pin

3

Ground

GPO

1

5V supply.

2

Digital output pin

3

Ground

DA

1

5V supply.

2

Analog output pin

3

Ground

PWM

1

5V supply.

2

PWM output pin

3

Ground

AD0/1/2

1

5V supply.

2

Analog input pin

3

Ground

IIC

1

5V supply.

2

Ground

3

Data wire of IIC

4

Clock wire of IIC

Ethernet module SPI

1

5V supply.

2

Ground

3

Chip select pin(Low active)

4

Chip reset pin(Low active)

5

Chip data input pin

6

Chip clock input pin

7

Weak on Line output pin(Low active)

8

Chip data output pin

9

Chip programmable clock output pin

10

Interrupt output pin(Low active)

Downloads

Connectivité
Adresse de la page produit fabricant
Mémoire Flash (programme)
Type de composant
Couleur
Fréquence Radio
Couleurs d'affichage
Colonne de rangement
Voltage
3.3v,5.5v
Code Fabricant
Tension en entrée
Prix d'achat
Google Product Type
Package
Type d'affichage
Zone de stockage
Résolution d'affichage
Etage de rangement
Nouveau produit
No reviews

Les clients qui ont acheté ce produit ont également acheté...

Product added to wishlist
Product added to compare.