Une grande bread-board contenant deux de taille moyenne parfaite pour tous vos prototype ou pour avoir sur votre établi. Elle a même trois connecteurs sur la plaque et deux rails doubles par platine pour le courant, permettant ainsi d'avoir plus d'un niveau de voltage (3.3 et 5v par exemple).
The A4988 stepper motor driver carrier is a breakout board for Allegro’s A4988 microstepping bipolar stepper motor driver. The driver features adjustable current limiting, overcurrent and overtemperature protection, and five different microstep resolutions (down to 1/16-step). It operates from 8 – 35 V and can deliver up to approximately 1 A per phase...
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Put on your sunglasses before using this matrix with 64 eye-blistering RGB LEDs adorn the panel for a blast of configurable color. Arranged in a 8x8 matrix, each pixel is individually addressable. Only one pin is required to control all the LEDs. You can cut a trace and use nearly any other pin if you need some customization.
This is battery level display module based on battery style digital tube LED. The 5 - segment LED inside is red light and the frame is green light. There is driver chip TM1651 onboard, so the control interface is simple, just two signal lines and VCC / GND. It can be used to display the battery power.
Tap to zoom
You need to login or create account
Save products on your wishlist to buy them later or share with your friends.