Your cartThere are no more items in your cart
MTH02 Digital Temperature & Humidity Sensor (High precision relative)
ECRSEM02001SLast items in stock
Digital high precision temperature & humidity sensor
Japan's Hokuriku resistive humidity sensor production as a Temperature & Humidity sensor.
- Test and testing equipment;
- Automatic control;
- Weather station;
- Humidity regulator;
- Measure the relative temperature and humidity sensor (humidity range 18% - 98% temperature range - 40 °C - 70 °C);
- Precomputed temperature and humidity sensing, without additional calculation;
- High precision plus or minus 3% RH (maximum not more than plus or minus 5% RH), + / - 0.5 °C;
- Can calculate dew point;
- Completely calibration, digital output;
- Good long-term stability;
- Low power consumption, 3 V - 5.5 V (minimum 2 V) power supply;
- Automatic cut-off;
Wiki & External links
Customers who bought this product also bought:
no odor finely drilled tough including power pad. Clean hole
The Screw Shield extends all pins of the Arduino out to 3.5mm pitch screw terminals. It also has a lot of the utility provided by Arduino Protoshield, including: a large prototyping space of both connected and unconnected 0.1" spaced through-holes, a couple 5V and GND busses, a reset button, and a 5mm green LED.
Using sensors MPU6050, HMC5883L and BMP085, this 10 degrees of freedom IMU will add a whole new world of sensing to your new project.
Non-invasive current transformer, use this sensor clip to build your own Personal Energy Monitor.
This is a digital temperature sensor, that is already calibrated. The measurement is done where the sensor is, no need for long insulated wire or complicated ADC design. This sensor is therefore also perfect for use with a Raspberry Pi, as it is not analogic, all the data is transmitted in digital One Wire protocol.
EMG detector is a bridge connects human body and electrical, the sensor gathers small muscle signal then process with 2th amplify and filter, the output signal can be recognized by Arduino. You can add this signal into your control system. Note: The sensor cannot be used for medical purposes. In standby mode, the output voltage is 1.5V. When detect muscle...
This is a simple male header, very useful for a lot of things, including to plug boards like the arduino on your protoboards.
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.