Your cartThere are no more items in your cart
2WD Arduino Mobile platform (Arduino Compatible) (Robotique)
€35.00 €45.00 -€10.00
This a well designed, Arduino compatible mobile robot development platform,you can build it and program it easily with tons of published free codes. Compare with the last mobile platform, this one has a tough aluminium body with mounting holes, you can add Variety of sensors to make it more interesting.
• 2WD Arduino compatible mobile robot development platform
• 2 high-quality micro-speed motor
• Tough aluminium body with mounting holes
• Variety of sensors can be added
• 2WD Mobile platform Motors: 3-6V DC
• Speed: 70cm/S
• Dimensions: 170mm（diameter）
• Weight: 400g
Aluminium chassis X1
Omni-directional Wheel x1
Customers who bought this product also bought:
Motor Shield L293D Motor Stepper Servo Shield...
Here is a design for a full-featured motor shield that will be able to power many simple to medium-complexity projects.
ATMega 328 with Arduino UNO R3 bootloader...
ATMega328 32K microcontroller with pre-loaded Arduino UNO bootloader
WTV020-SD Music/Voice Play Module MP3 (Micro...
This very tiny module (the size of the micro sd card reader) reads voice and music from the sd card, as needed from your micro-controller.
Dual female splittable jumper wires (300mm, 40...
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Battery Holder 6 x AA Barrel Jack
The 6x AA Battery Holder puts a nice finishing touch on your battery powered project.
Male Male Deluxe (reinforced) Breadboard jumper...
Whenever you want to use a breadboard for prototyping you need wires and preparing wires is long. Those wires are already prepared and come in four different sizes in the pack. Unlike other wires you can find on the web, those are reinforced, with a molded barrel and a real connector. No more open circuits or bad connections in your circuits with those...
Battery Holder - 4 x AA
A prototype AA battery case, it has on/off switch on the case, and it can be fully closed by cap and further screw it to close, so it’s very well protected.
Motor Shield Arduino compatible – VNH2SP30
Description This is essentially a ramped up version of our Ardumoto motor driver shield. For this monster shield we’ve replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. We’ve also beefed up the support circuitry so this board is capable of driving a pair of high-current motors! The VIN and motor out are pitched for our 5mm...
Breakout for Raspberry Pi to Breadboard...
This is a T-Cobbler breakout kit used for extending the GPIO interface on Raspberry Pi to breadboard. It helps you to make the connections between Raspberry Pi and breadboard become simple.
0.1" (2.54mm) Female header 1 row / 40 pins
This is a simple female header, very useful for a lot of things, including to plug boards like the stm32f4 discovery or the arduino nano on your protoboards.