Your cartThere are no more items in your cart
2WD Arduino Mobile platform (Arduino Compatible) (Robotique)
SESROB102F3MLast items in stock
€35.00 €45.00 -€10.00
This a well designed, Arduino compatible mobile robot development platform,you can build it and program it easily with tons of published free codes. Compare with the last mobile platform, this one has a tough aluminium body with mounting holes, you can add Variety of sensors to make it more interesting.
• 2WD Arduino compatible mobile robot development platform
• 2 high-quality micro-speed motor
• Tough aluminium body with mounting holes
• Variety of sensors can be added
• 2WD Mobile platform Motors: 3-6V DC
• Speed: 70cm/S
• Dimensions: 170mm（diameter）
• Weight: 400g
Aluminium chassis X1
Omni-directional Wheel x1
- Mémoire RAM (vive)
- Etage de rangement
- Compatibilité avec les cartes
- Watts (sortie)
- Adresse de la page produit fabricant
- Google Product Type
- Vitesse d'horloge
- Type de CPU
- Couleurs d'affichage
- Mémoire Flash (programme)
- Colonne de rangement
- Watts (entrée)
- Code Fabricant
- Famille de micro-controlleur
- Coeurs CPU
- Fréquence Radio
- Display Type
- Tension en entrée
- Zone de stockage
- Résolution d'affichage
Customers who bought this product also bought:
This is a simple female header, very useful for a lot of things, including to plug boards like the stm32f4 discovery or the arduino nano on your protoboards.
TI's MSP430 Launchpad board is a perfect start in the MSP430 family with the value line chips (msp430g2xxx). With the fact that you an easily remove the chip to put in your own circuit or program nearly all the msp430f2xxx and msp430g5xxx chips, it makes for a great project factory at a very low price. Also, the pack comes with two micro-controllers (you...
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Half size breadboard that is perfect for small prototypes. It does even have power rails on the sides to allow for more than one power level.
5 cm (2") 3W 8 Ohm miniature speaker with a plastic basket and plastic diaphragm. Broad frequency response and good voice reproduction. Particularly well suited to outdoor applications and where ambient conditions are generally unfavourable (e.g. high humidity).
This very tiny module (the size of the micro sd card reader) reads voice and music from the sd card, as needed from your micro-controller.
This is a T-Cobbler breakout kit used for extending the GPIO interface on Raspberry Pi to breadboard. It helps you to make the connections between Raspberry Pi and breadboard become simple.
800x600, 4.3inch serial interface electronic paper display
This is a light weight, high energy density polymer lithium battery. It outputs a nominal 3.7v at 980mAh, including built-in protection against over voltage, over current, and minimum voltage. It comes terminated with a standard 2-pin JST connector-2.54 mm spacing between pins. Please do not attempt to charge these with anything but a specialized...
The Motor Shield is a driver module for motors that allows you to use Arduino to control the working speed and direction of the motor. Based on the Dual Full-Bridge Drive Chip L298, it is able to drive two DC motors or a step motor. The Motor Shield can either be powered directly by Arduino or by an external 5V~15V power supply via the DC jack. This...