The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip. The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The...
This a well designed, Arduino compatible mobile robot development platform,you can build it and program it easily with tons of published free codes. Compare with the last mobile platform, this one has a light body with mounting holes, you can add Variety of sensors to make it more interesting.
This panache countains 20 wires of each kind, dual male, male female and dual female. A total of 60 wires.
Every kind is assembled as one splittable cable and can be transormed from 1-20 pin jumper wire.
With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
The Raspberry Pi Camera Module is a custom designed add-on for Raspberry Pi. It attaches to Raspberry Pi by way of one of the two small sockets on the board upper surface. This interface uses the dedicated CSI interface, which was designed especially for interfacing to cameras. The CSI bus is capable of extremely high data rates, and it exclusively...
This is a T-Cobbler breakout kit used for extending the GPIO interface on Raspberry Pi B+,2 or 3 to breadboard. It helps you to make the connections between Raspberry Pi B+/2/3 breadboard become simple.