Your cartThere are no more items in your cart
Trimmer Potentiometer (100mW, 6.5 x 7 x 4.2mm, various values)
Those potentiometer are great little tools that can be easily used on your prototypes to enter custom resistor values.
Customers who bought this product also bought:
Wires and Connectors
Manufacturer WAGO Type of splice terminal installation quick splice Electrical mounting spring clamp Wire cross section 0.2...4mm2 Connector series 221 Mechanical mounting for cable Rated voltage 450V Current rating 32A Number of ways 1 Number of terminals 2 Connector variant with lever
High power mosfet to switch all your devices/leds/motors easily. This is the P-type, meaning you have to put it between the load and the ground.
This is a power module for the standard bread boards (Small and Medium sized). It's concave design so will not wast your proto zone. It also supports both 5v and 3.3v (both can be enabled on each power rail). We think it is a must to have on your workbench, really.
Nice cable with a good section, when you need more power.
The 433M RF link kit is consisted of transmitter and receiver, popular used for remote control. 433MHz frequency and ASK modulation.
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Nice little red matrix with easy-to-use backpack included
This is a common female barrel jack connector for pcb or cable mounting. 2,5mm inner pole, 5 to 5.5mm outside.
A simple 50k ohm vertical linear potentiometer for all your projects.
Easy to use Darlington Transistor Array for all your projects.