Raspberry Pi 7” TouchScreen Display ( HDMI LCD, 1024×600 )

LCDWSH7P1024600
Out-of-Stock
€84.00
Tax included

The 7” Touch screen Monitor for Raspberry Pi gives users the ability to create all - in - one, integrated projects such as tablets, infotainment systems and embedded projects. The 1024 x 600 display connects via an adapter board which handles power and signal conversion. Only two connections to the Pi are required; power from the Pi’s GPIO port and a ribbon cable that connects to the DSI port present on all Raspberry Pi’s. Touch screen drivers with support for 10 - finger touch and an on - screen keyboard will be int egrated into the latest Raspbian OS for full functionality without a physical keyboard or mouse.

Features

  • 1024×600 high resolution
  • Resistive touch control
  • Compatible and Direct-connect with any revision of Raspberry Pi (except the Pi 1 model B or Pi Zero, which requires an HDMI cable)
  • Drivers provided (works with your own Raspbian/Ubuntu directly)
  • Also works as a computer monitor, in this case, touch panel is unavailable and HDMI cable is required
  • HDMI interface for displaying, no I/Os required (however, the touch panel still needs I/Os)
  • Multi-languages OSD menu, for power management, brightness adjustment, contrast adjustment, etc.
  • Supports 100-level backlight adjustment
  • Interface

    PIN NO.SYMBOLDESCRIPTION
    1, 17 3.3V Power positive (3.3V power input)
    2, 4 5V Power positive (5V power input)
    3, 5, 7, 8, 10, 11, 12, 13, 15, 16, 18, 24 NC NC
    6, 9, 14, 20, 25 GND Ground
    19 TP_SI SPI data input of Touch Panel
    21 TP_SO SPI data output of Touch Panel
    22 TP_IRQ Touch Panel interrupt, low level while the Touch Panel detects touching
    23 TP_SCK SPI clock of Touch Panel
    26 TP_CS Touch Panel chip selection, low active

    External Dimension

    7inch-HDMI-LCD-dimension

    Development Resources

    Wiki : www.waveshare.com/wiki/7inch_HDMI_LCD

    FAQ

    Why the LCD doesn't work with my Raspbian?
    To use the LCD with the Raspberry Pi official image, driver should be installed first. Please refer to the user manual.
    However, for the first testing, you may want to use our provided image directly.
    Why the LCD still doesn't work with the Waveshare provided image?
    Make sure the hardware connection is correct and connects fine.
    Make sure the image in TF card is burnt correctly.
    The PWR will keep on and the ACT will keep blinking when the Raspberry Pi starts up successfully, in case both of the two LEDs keep on, it is possible that the image was burnt incorrectly OR the TF card was in bad contact.
    Which power supply should I use?
    It is strongly recommended to use a stand-alone 5V/2A power adapter, because the PC's USB port might have not enough power to support the Pi and LCD.

New product
No reviews

Customers who bought this product also bought:

Product added to wishlist
Product added to compare.