Your cartThere are no more items in your cart
HackSpark Basic Lite pack kit for Arduino and other MCUs (breadboard, cables, leds, buttons, etc.) (Arduino Compatible)
This little pack contains a cheap but good base to begin with Arduino or other micro-controllers.
1.400 Holes Bread Board * 1
2.Colorful Bread Line * 30
3.Resistor 100R * 10
4.Resistor 220R * 10
5.Resistor 330R * 10
6.Resistor 1K * 10
7.Resistor 4.7K *10
8.Resistor 10K * 10
9.Resistor 47K * 10
10.Resistor 100K * 10
11.Ceramic Capacitor 100PF * 10
12.Ceramic Capacitor 10NF * 10
13.Ceramic Capacitor 100NF * 10
14.Ceramic Capacitors 2.2NF * 10
15.Electrolytic Capacitor 10UF * 10
16.Electrolytic Capacitor 470UF * 10
17.LED Green * 10
18.LED Red * 10
19.LED Yellow * 10
20.LED Blue * 10
21.Button Switch Green * 2
22.Button Switch Red * 2
23.Button Switch Yellow * 2
24.Button Switch Blue * 2
25.Pin 1 * 40 *1
26.Potentiometer 10K * 1
27.LED RGB * 2
28.Buzzer * 2
29.Resistance Card * 1
30.Plastic Box * 1
Customers who bought this product also bought:
Deluxe heavy duty stand with sponge that can be used to hold an electric soldering iron.
Great for truck, Boat, Racing Car, Helicopter and Airplane. mg995
ULN2003 Stepper Motor Driver Board is use the ULN2003 DARLINGTON ARRAYS to drive the 4-phase 5-wire stepper motors (5v-12v).
If you are searching an ultrasonic ranging module, the HC-SR04 is good choice: Its stable performance and high ranging accuracy make it a popular module in electronic market. It's cheaper than an IR range finder with similar range accurancy and distance.
Stock up on your LED display units with this 8 x 8 red dot matrix. Ideal for use in your electrical and test equipment, the dot matrix emits a bright glow.
PN532 NFC module, as its name implies, is based on PN532 chip and used for 13.56MHz near field communication. The module is equipped with onboard antenna, thus no external antenna coil is needed. It is compatible with SPI, IIC and UART interface for communication. With NFC library support for Arduino and Raspberry Pi offered by us, it is quite...
Light weight,comfortable general purpose.This series are designed for laboratory,household repair soldering.
GY-BME280 is a Breakout Board featuring a Bosch Sensortec BME280 Temperature, Humidity & Pressure Sensor. The board has selectable I2C address jumper (solder link GS2), I2C pull-up resistors, 7 pin header 2.54mm, and two mounting holes 3.5mm. Default setting of the board; single power rail Vdd=Vdd_IO (solder link GS1), pull-ups resistors (R2, R3) 10k,...
The RS232 to TTL converter module is widely used in radio modifications,phone flash, XBOX360 flash, GPS, vehicle detection, DVD flash, hard disk repair set-top box upgrade. It can be used to program STC MCU, NXP MCU,Renesas MCU, STM32 MCU, N+-2EC MCU.