Your cartThere are no more items in your cart
ITDB02 Arduino Mega Shield (Arduino Compatible)
The ITDB02 LCD modules works in 3.3V voltage level and are not compatible with Arduino Mega pins, for that reason, this Arduino MEGA shield connects with these LCDs. Now you can directly plug the ITDB02 Series LCDs in the shield and stand on the Arduino board.
ITDB02 Arduino Mega shield support both 3.3V mainboard and 5V mainboard, so it not just can be used with Arduino but can with other Arduino compatible mainboards , like ChipKit UNO32 or Arduino DUE.
Customers who bought this product also bought:
A single pack of 10 resistors of the same value, useful for a single project where you need a particular resistor value.
The 433M RF link kit is consisted of transmitter and receiver, popular used for remote control. 433MHz frequency and ASK modulation.
With compact design, the board can integrate the real-time clock module DS1307, EEPROM memory AT24C32 and digital temperature sensor DS18B20 (not supplied on the board) which are connected via I2C bus together on a 27mm*28mm*8.4mm board.
Senses when a door or window is open or closed... Perfect for use with your favourite micro controller board (be it arduino, launchpad, stm3é or whatever) !
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 ESP12E wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.
This is a simple adapter from 9v batteries to a barrel jack connector, very useful for Arduino and other mcu board with a barrel jack adapter.
It's a breakout board for W5100 embedded TCP/IP chip. Included on the board is an RJ-45 with X’FMR connector. It can be used as a component and little effort is required to interface to the W5100. This module is an ideal option for users who want a simple solution to adding TCP/IP capability to their project.