Your cartThere are no more items in your cart
NanoPi NEO Heat Sink
HEATNANOPISINKLast items in stock
It's good to get the best.
Customers who bought this product also bought:
You can simply plug this USB Wifi dongle into the USB port of your Dev Board and you're ready to connect to a nearby wireless network!
Very useful kit of nylon screw, nuts and spacers.
The very popular 595 shift register chip of the 74 series is used a lot by hobbyis because of its wide availability, good speed and simplicity. Just plug it on an arduino like shown in the tutorials and youi have 8 more outputs, put two and you have 16 more outputs ! (up to a lot of them actually, with only three pins !)
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 ESP12E wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.
This is a digital temperature sensor, that is already calibrated. The measurement is done where the sensor is, no need for long insulated wire or complicated ADC design. This sensor is therefore also perfect for use with a Raspberry Pi, as it is not analogic, all the data is transmitted in digital One Wire protocol.
This is a variable resistor based on temperature, giving you an accurate value based on calibration.
Amphenol FCI USB Connector, MICRO USB F, USB 2.0, Receptacle, 4 Way SMD / CMS
It is going to surprise you.