IR

2
Available
Dev. Tools

Raspberry Pi 5 MP Wide Angle Camera with Night...

SENRPIIRLED
€20.83
Raspberry Pi 5 MP Wide Angle Camera with Night Vision sensor IR  On board photoresistor, on board adjustable resistor; Operation: connect LED board and PCB board of camera w/ screw, adjust resistor of LED board (IR light auto work when it is dark and auto off if it is bright)
2
Out of stock
Sensors

MLX90614 contactless infrared measuring...

SENJANGY906
€10.42
MELEXIS MLX90614ESF-BAA-000-TU-ND non-contact infrared thermometer for use with (for)Arduino, or any microcontroller that can communicate with it through it's I2C interface. This sensor comes with a breakout board with all of the components needed for operation and two types of pins.  They are unsoldered.  Please indicate if you would like one or the...
View
Available
Electronics

Infrared Kit - IR Receiver (HS0038) + IR LED...

IRELDRECTRANS
€0.79
hs0038 IR sensor tuned to 38KHz, perfect for receiving commands from a TV remote control. Runs at 5V (although it seems to be OK down to 3.3V)To use, connect pin 3 (all the way to the right) to 5V power, pin 2 (middle) to ground and listen on pin 1. It doesn’t do any decoding of the signal, just passes the ‘raw data’ along.
2
Out of stock
Grove

Grove - Infrared Receiver

SEDGROIRREC
€4.00
The Infrared Receiver is used to receive infrared signals and also used for remote control detection. There is a IR detector on the Infrared Receiver which is used to get the infrared light emitted by the Infrared Emitter.
View
Available
Grove

Grove - Infrared Emitter

SEDGROIREMI
€4.00
The Infrared Emitter is used to transmit infrared signals through an infrared LED, while there is an Infrared receiver to get the signals on the other side . An infrared LED is like any other LED, with its color centered around 940nm. We can use the emitter not only to transmit data or commands, but also to emulate remotes to control your home appliance...
IR
Product added to wishlist
Product added to compare.